Image Gallery:

Product Information

The Tracer is designed for the F3B or F3F contest class. You can of course fly it as a sports model just for fun. Construction wise It has a two piece Full Carbon wing with fuselage and tails made from a combination of carbon, glass and kevlar. The fuselage is Carbon/Kevlar from the front of the wing back to the tail for stiffness but the nose area where your receiver and servos sit, is 2.4GHz friendly and no carbon is used in that area. The tail is removable in two pieces which make transportation easy, they are held in place with 5mm carbon dowels.

The wing has ballast tubes fitted front and rear of the wing joiner allowing you to increase the weight by 1000g if necessary. The model is very affordable by today's standards and offers excellent performance for the price. The finish and construction is to the very high standards we are now used to from NAN Model.

Fuselage push-rods are pre installed and it comes with a complete hardware pack. A complete wiring harness available from the shop.

• Specification
• Recommended Servos
• Forum Build Help
• Reviews(1)

Wing Span: 3000mm
Fuselage Length: 1500mm
Wing Area: 60dm2
Airfoil: NAN Special
Flying Weight: From 2200g

Graupner DS368 (Ailerons, Flaps, Elevator, Rudder)
Graupner DS3068 (Ailerons, Flaps, Elevator, Rudder)
Graupner DS3288 (Ailerons, Flaps)
Graupner DES 448 BB MG (Ailerons, Flaps)

Click Here

Click Here

(Based on 1 Reviews)

Reviews / Comments

Dream Machine

"I purchased the Tracer in an effort to acquire a good all round slope glider for most conditions; little did I know that it would turn out to be the best model I have flown over many years. The quality of the build was superb and the installation of the RC gear presented no problems. I’m still slowly moving the C of G rearward a little at a time, as I started off about 15mm forward of the suggested setting. From the first launch it was clear to me just how good the model handled, all that was needed was 3 clicks of down trim in a 16mph wind, turns and loops were smooth and accurate. From now on this will be my model of first choice when I arrive at the slope. So well done to Acemodel for a great product. "

May 27 2011, 13:06 PMby Clive Cobley

• Write review / comment

Price: £699.95

• Tell a Friend
• Read customer reviews
• Write review / comment

Recommended Accessories:
	Add Wiring Harness @ £35.99 (details) Model Type: Omega Orion Xplorer 3500 Xplorer 3800 Xplorer 4000 Xplorer 3500 E X Tail Xplorer 3500 E V Tail (+£3.00) Xplorer 3800 E X Tail Xplorer 3800 E V Tail (+£3.00) Xplorer 4000 E X Tail Xplorer 4000 E V Tail (+£4.00) Alex XXL X Tail Alex XXL E X Tail Alex XXL V Tail Alex XL X Tail Alex XL E V Tail Alex XL E X Tail Alex XL V Tail Alex Mini Alex Mini E Alex Mini E II Shadow E V Tail Shadow E X Tail Shadow V tail Shadow X Tail Alex F5B Tracer Servo Connection Type: Futaba JR